This is an immutable branch shared between wireless-drivers-next and
staging-next for moving wilc1000 driver out of staging to drivers/net/wireless
directory.
WILC1000 is an IEEE 802.11 b/g/n IoT link controller module. The
WILC1000 connects to Microchip AVR/SMART MCUs, SMART MPUs, and other
processors with minimal resource requirements with a simple
SPI/SDIO-to-Wi-Fi interface.
WILC1000 driver has been part of staging for few years. With
contributions from the community, it has improved significantly. Full
driver review has helped in achieving the current state.
The details for those reviews are captured in 1 & 2.
Merge ath-next from git://git.kernel.org/pub/scm/linux/kernel/git/kvalo/ath.git
ath.git patches for v5.9. Major changes:
ath11k
* add 6G band support
* add spectral scan support
01e3423...
by
Venkateswara Naralasetty <email address hidden>
ath11k: fix wmi peer flags in peer assoc command
Currently need ptk/gtk wmi peer flags in wmi peer assoc cmd
are set based on the rsnie and wpaie of the bss from the bss list.
Since this bss list is not updated with current BSSID for AP mode,
we may not find bss from the bss list. Which results in ptk/gtk peer
flags are not set in the wmi peer assoc cmd. Due to this EAPOL frames
are going in data rates instead of management rates.
Add support for dp tx error stats which logs tx failure reasons due
to ring full condition, etc. This stats is added in soc_dp_stats
which was earlier used as soc_rx_stats so that all dp related info
are logged in same file.
Signed-off-by: Sriram R <email address hidden>
Signed-off-by: Kalle Valo <email address hidden>
Link: https://<email address hidden>
8cacd03...
by
Sowmiya Sree Elavalagan <email address hidden>
ath11k: removing redundant reo unlock followed by immediate lock
Removed reo cmd lock and unlock which was acquiring the lock immediately
after unlock. Done for code clean up.
Signed-off-by: Sowmiya Sree Elavalagan <email address hidden>
Signed-off-by: Kalle Valo <email address hidden>
Link: https://<email address hidden>
9d11b7b...
by
Karthikeyan Periyasamy <email address hidden>
ath11k: add support for spectral scan
spectral scan control interface is exposed through debugfs eentry.
Relayfs is used to collect the spectral data. These interfaces are
similar to ath10k spectral.