Merge patch series "omap3: Make SPL_OMAP3_ID_NAND depend on NAND_OMAP_GPMC"
This series results in making it such that with CONFIG_MTD disabled we
then do not prompt the user for a number of memory technology device
related options and so clean up our configuration menu / display.
mtd: Make CONFIG_MTD be the gate symbol for the menu
The help for CONFIG_MTD explains that it needs to be enabled for various
things like NAND, etc to be available. It however then doesn't enforce
this dependency and so if you have none of these systems present you
still need to disable a number of options. Fix this by making places
that select/imply one type of flash, but did not do the same, also do
this for "MTD". Make boards which hadn't been enabling MTD already but
need it now, do so. In a few places, disable CONFIG_CMD_MTDPARTS as it
wasn't previously enabled but was now being implied.
cmd/flash: Make this default y for CFI and NOR only
This command is only useful on CFI and NOR type flashes and not others.
Update the dependency so that it's not enabled by default in other
cases. This will lead to a number of platforms no longer building this
command, where it was not useful.
env: Make ENV_IS_IN_SPI_FLASH depend on SPI flash being present
In order for our environment to be present on SPI flash we need to
depend not on the symbol for a SPI controller but rather that SPI flash
of some sort is present. Update the dependencies.
omap3: Make SPL_OMAP3_ID_NAND depend on NAND_OMAP_GPMC
This specific bit logic is used to determine what NAND chip is present
on a board in order to then know what revision of the board we have and
so what DDR chips are present. We can only do this if we have a NAND
chip, and so we will have NAND_OMAP_GPMC enabled.
Signed-off-by: Tom Rini <email address hidden>
33e06dc...
by
Shantur Rathore <email address hidden>
common: usb-hub: Reset hub port before scanning
Currently when a hub is turned on, all the ports are powered on.
This works well for hubs which have individual power control.
For the hubs without individual power control this has no effect.
Mostly in these scenarios the hub port is powered before the USB
controller is enabled, this can lead to some devices in unexpected
state.
With this patch, we explicitly reset the port while powering up hub
This resets the port for hubs without port power control and has
no effect on hubs with port power control as the port is still off.
Before this patch AMicro AM8180 based NVME to USB adapter won't be
detected as a USB3.0 Mass Storage device but with this it works as
expected.
Tested working after this patch:
1. AMicro AM8180 based NVME to USB Adapter
2. Kingston DataTraveler 3.0
3. GenesysLogic USB3.0 Hub
The drives were tested while connected directly and via the hub.
- Allow i.MX8M Plus DHCOM to operate in overdrive mode.
- Allow i.MX8M Plus eDM SBC to operate in overdrive mode.
- Enable the 'kaslrseed' command on DH i.MX8M Plus DHCOM.
- Select LTO by default on i.MX8M.
- Convert pico-dwarf/hobbit-imx6ul to CONFIG_DM_SERIAL.
- Fix 'reset' command on wandboard.
