qpdfview

lp:~adamreichold/qpdfview/trim-margins

Created by Adam Reichold on 2014-08-17 and last modified on 2014-08-23

Only Adam Reichold can upload to this branch. If you are Adam Reichold please log in for upload directions.

No branches dependent on this one.

Wishlist

Fix Released

1662. By Adam Reichold <email address hidden> on 2014-08-23: Remove the now unnecessary, reduce the padding and do some minor performance optimization.
1661. By Adam Reichold <email address hidden> on 2014-08-22: Make sure not to clip the decorating border pen when trimming margins.
1660. By Adam Reichold <email address hidden> on 2014-08-19: Tighten the crop rect tolerance somewhat to around 4% per dimension.
1659. By Adam Reichold <email address hidden> on 2014-08-19: Couple the crop rect life cycle to the obsolete pixmap lifecycle.
1658. By Adam Reichold <email address hidden> on 2014-08-19: Properly truncate our crop rect tolerance.
1657. By Adam Reichold <email address hidden> on 2014-08-19: Set the crop rect only once for every refresh on the PageItem level.
1656. By Adam Reichold <email address hidden> on 2014-08-19: Round crop rects only once for tiling and without it.
1655. By Adam Reichold <email address hidden> on 2014-08-18: Make sure to round crop rect after combining it from several tiles.
1654. By Adam Reichold <email address hidden> on 2014-08-17: Limit page cropping to one-third on each side.
1653. By Adam Reichold <email address hidden> on 2014-08-17: Do not reset crop rect on refresh to break feedback loops at the cost of temporarily incorrect crop rects.

This branch contains Public information

Everyone can see this information.